SiloTreat^® Agraff is a water-repellent and permanent oil and water-soluble graffiti protection for mineral building materials.

The product penetrates deep into the base and makes it hydro and oleophobic.

It contains practically no volatile organic compounds.

SiloTreat^® Agraff provides waterproof protection that is vapour permeable at the same time.

Areas of application:

• Concrete
• Brick/clinker
• Sandstone (not Udelfanger sandstone)
• Sand limestone
• Mineral-based stucco (with limits)
• Marble and granite

Application method:

• SiloTreat^® Agraff is applied using High Volume Low Pressure (HVLP) spray guns (at low operating pressure, not more than 0.7 bar / 10 psi with nozzle sizes from 1.3 to 1.5 mm.).
• Apply the product without interruption in consecutive horizontal lines from bottom to top without repeating.
• Large drops should be removed as soon as possible with a brush.
• The product must be protected for at least 4 hours before coming into contact with liquids.
• In order to obtain longer-lasting protection against graffiti, it is recommended to apply an additional layer of the product. The surface must dry completely between each step.
• The amount of product required for the application of each subsequent hand is significantly less.

Indicative Consumption*:

• Mineral building materials - 30 - 150 ml / m2 *

* Average consumption rate - the indicated quantities are indicative, as the consumption rate for each specific application depends on the absorption capacity of the surface.

Package:

• spray bottle - 1 litre.
• tube - 5 litres, 20 litres.

Product for professional use only.